Herunterladen Inhalt Inhalt Diese Seite drucken

Ariete You&me 1323 Gebrauchsanleitung Seite 18

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 20
UK
Cleaning the Thermocream® plate (13)
Remove the disc from the filter holder and rinse it under running water.
Cleaning the filter holder hook seat
With use, the filter holder hook seat may become soiled with coffee grounds that can be cleaned off
with a sponge (Fig. 13).
Cleaning the MAXI CAPPUCCINO device (3)
WARNING: To prevent the risk of scalding, only clean the MAXI CAPPUCCINO device (3) once it is
cool.
Unscrew the device from its support pipe (Fig. 14), and wash it under running water. The pipe can be
cleaned with a non-abrasive cloth. Screw the MAXI CAPPUCCINO (3) device back until it clicks into
place, but make sure not to tighten it excessively. If necessary, use a pin to clean the steam dispens-
ing hole.
Cleaning the removable cup grille (6) and drip tray (5)
- Remove the cup grille (6) and drip tray (5) (Fig. 15).
- Wash both under running water and dry them.
- Refit the drip tray (5) slotting the four bottom holes onto the four pegs in the base (Fig. 16).
- Refit the grille (6) by placing one of the alignment holes level with the tab on the drip tray (Fig. 17).
DECALCIFICATION OF THE COFFEE MAKER
The coffee maker requires regular decalcification. The frequency depends on the quality of the water
used and the amount the maker is used.
In any case, it is strongly advised that you decalcify the coffee maker every 800 uses,(or about every
6 months). Use NOCAL by Ariete, available at Authorised Assistance Centres.
Proceed as follows:
- Remove the filter holder from its hook.
- Dissolve one full tea-spoon of decalcifying product (about 8 g.) in 1 measure (14) of warm water
(about 220 ml), pour the solution into the boiler and close the boiler cap.
- Place a container under the coffee dispenser lip (with the filter holder removed), and another con-
tainer under the steam arm.
- Bring the lever (7) to the pre-heat position (Fig. 5).
- Once the sound signal comes on, wait 2 minutes, then dispense one cup of water bringing the lever
completely forward (Fig. 6).
- Push the lever back to the pre-heat position, and immediately dispense the steam from the MAXI
CAPPUCCINO device (3).
- Repeat the entire procedure once more, ALWAYS following the steps described in the paragraph
"Successive use".
The decalcifying product remaining in the packet can be stored in a dry place for the next time you
decalcify the coffee maker.
Once finished decalcifying the coffee maker, rinse the boiler well with fresh water, then run the machine
14

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis