Making Cappuccino - Ariete You&me 1323 Gebrauchsanleitung

UK
- Pull the power lever (7) all the way forwards to begin dispensing the coffee (Fig. 6).
The sound signal may continue even during coffee dispensing.
If coffee dispensing is not begun immediately, the appliance will continue to emit its sound
signal for the entire time that the water in the boiler tank is at the correct temperature.
In any case, we recommend that you do not wait too long before dispensing coffee because this could
alter the taste, leading to coffee with a burnt flavour.
- Once the coffee has reached the required level in the cup, stop dispensing by moving the lever (7)
back to the upright standby position (Fig. 7).
If the lever (7) is not moved back to the upright position after use, small amounts of water and steam
may leak out from the coffee dispensing nozzles for as long as there is water in the boiler tank. This
does not mean that the appliance is malfunctioning. To resolve this problem, it is sufficient to move
the lever (7) to the upright standby position.
WARNING: After dispensing coffee, wait at least ten seconds before removing the filter holder, which
must be taken out slowly to prevent water or coffee splashes.
Successive use
- To dispense more coffee immediately after, proceed as follows:
- Slowly unhook the filter holder from its seat and clean off any coffee grounds from the previous cof-
fee dispensed.
- Place the empty water measure under the MAXI CAPPUCCINO device (3) and release all residual
steam inside the boiler by holding down the steam dispenser button (4) (Fig. 8). With the button
pushed, it is possible to bring the measure forward into its fixed position, allowing you to take your
finger off the steam dispenser button and simply wait for the remaining residual steam to discharge.
- When the steam is all out, move the device (3) back to its initial position, pushing it back with the
measure (Fig. 10).
- Unscrew the safety cap to refill the boiler tank and then follow the steps described here above.
WARNING: : The boiler tank cap is fitted with a safety valve which allows it to be unscrewed only if
all residual steam has been completely released.

MAKING CAPPUCCINO

To make a cappuccino or hot chocolate, or to heat any other beverage, proceed as follows:
If the coffee has already been prepared:
- Move the power lever (7) to the pre-heat position (Fig. 5). In this position, the boiler tank remains
pressurised without dispensing any liquid from the nozzles on the filter holder.
- Place the container of milk to be foamed (or liquid to be heated) under the MAXI CAPPUCCINO
device (3) and press the steam button (4) to start the jet of steam (Fig. 11). While holding down
the button, you can move the milk container forwards until it is in the fixed position, allowing you
to remove your finger from the steam button and to wait until the milk is ready following the direc-
tion of rotation of the device (3) as shown in Fig. 9. During steam dispensing the sound signal may
go on and off, indicating that the boiler is maintaining its temperature.
WARNING: Before pressing the steam button to dispense a jet of steam, make sure that
12