CleanCraft HDR H-78-18 Bedienungs- Und Wartungsanleitung Seite 31

PRObLEM
T h e c l e a n e r r e s u m e s
operation spontaneously
when it is in Total Stop mode.
When the master switch (1) is
turned on, the engine hums
but does not start up.
The cleaner does not deliver
hot water
The cleaner will not start up
again and the warning light
(45) is lit.
The cleaner will not start up
again and the warning light
(47) is lit.
In Steam mode, the burner
does not start or stops
working and the warning
light (48) is lit.
Lamp (49) flashing
CAUSE
Leaks and/or drips in the delivery
circuit.
Unsuitable electrical system and/
or extension lead
There is not enough fuel in the
tank (warning light 44 is lit).
The fuel filter is dirty.
The boiler's safety thermostat
has tripped.
The burner controller has tripped
(warning light 49 is lit)
The cleaner has been inactive for
more than 15 minutes and has
entered Timed Shutdown mode.
Leaks have been detected in the
delivery circuit causing the
cleaner to restart several times:
the relative safety device has
tripped causing the cleaner to
stop working.
Pressure above 32 bar/464 psi.
Malfunction in some temperature
control device
SOLUTION
Inspect the delivery circuit for leaks.
Check the instructions for connecting
up to the mains power supply have
been followed correctly (refer to the
INSTRUCTIONS MANUAL – SAFETY
), especially as regards
INSTRUCTIONS
the use of an extension lead.
Top up with fuel.
F o l l o w t h e i n s t r u c t i o n s i n
"SUPPLEMENTARY MAINTENANCE".
Leave the cleaner to cool down for
a few minutes so the safety device
can reset.
SHOULD IT TRIP AGAIN, DO NOT USE THE
CLEANER AND CONTACT A qUALIFIED
.
TECHNICIAN
Turn the master switch (1) to "0", wait
a few seconds and then turn it to
SHOULD IT TRIP AGAIN, DO NOT USE THE
CLEANER AND CONTACT A qUALIFIED
.
TECHNICIAN
Follow the instructions in
THE CLEANER/INTERRUPTING THE
OPERATION – TIMED SHUTDOWN"
Turn the master switch (1) to "0",
wait for a few seconds and start up
the cleaner again.
SHOULD IT TRIP
AGAIN, DO NOT USE THE CLEANER AND
CONTACT A qUALIFIED TECHNICIAN.
Follow the instructions in
"OPERATING
THE CLEANER IN STEAM MODE"
Use the machine only in Cold Water.
CONTACT A qUALIFIED TECHNICIAN.
EN
.
"STOPPING
.
31