Panasonic CZ-RWSU2N Kurzübersicht Seite 5

Receiver
CZ-RWSU2N
CZ-RWSL2N
5
3 4
2
9
8 7
Operation Panel
3
4
OPERATION TIMER
1
STANDBY
2
5
For wall mounted type indoor unit (CZ-RWSK2)
1. Receiver
Receives the signal sent from the remote
controller.
2. Emergency operation button
Indicator lamps
When an error occurs, one of the lamps
fl ashes. When an indicator lamp is fl ashing,
refer to "Before Requesting Service".
3. OPERATION lamp
Lights up when the unit is operating.
4. TIMER lamp
Lights up when the timer is set.
5. STANDBY lamp
• The lamp in the HEAT mode lights up at
the following times: during the startup,
during the thermostat operation, and
during the defrosting.
• The lamp fl ashes when an error occurs.
6. FILTER lamp
This lamp is for notifying you when the fi lter
needs to be cleaned.
7. Address switch
Used to set the remote controller
addresses.
CZ-RWSD2
2
3 4 5 1
Display
1
2
3
4
5
CZ-RWSC3
1
2
3
4
5
6
Front side
CZ-RWST3N
2
3 4 5
Note
• If non-cooling/heating free type is being
used, it will beep twice and the operating
lamp will light up on the display; if the timer
and standby lamps blink alternately, a
confl ict between the heating and cooling
exists, so the unit cannot operate in the
desired mode. (On models that do not have
an Auto function, even if Auto is selected, it
works in the same way.)
• When the local operation is disabled by
centralized control or similar cause, and if
the Start/Stop , Mode
setting button
will beep fi ve times and the change will not
be made.
ADDRESS 1
ADDRESS 2
ADDRESS 3
REM SUB/MAIN
1 2 3 4
Rear side
1
or Temperature
is pressed, the unit
(EN)
5