Panasonic CZ-RWSU2N Kurzübersicht Seite 3

Safety Precautions
Note:
 This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
 This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the distributor or an experienced radio/TV technician for help.
 FCC Caution: To assure continued compliance, follow the attached installation
instructions. Any changes or modifi cations not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
NOTICE
The English text is the original instructions.
Other languages are translation of the original instructions.
Specifi cations
CZ-RWSU2N/CZ-RWSD2/CZ-RWSC3/CZ-RWSL2N/CZ-RWSK2/CZ-RWST3N
Wireless Remote
Controller
CZ-RWSU2N/CZ-RWSD2/CZ-RWSC3/CZ-RWST3N
Dimensions
Receiver
Power source
CZ-RWSL2N
Dimensions 37 mm (H) × 70 mm (W) × 22 mm (D)
Display
Power source 5 V DC (supplied from the operation panel)
Dimensions 55 mm (H) × 120 mm (W) × 16 mm (D)
Operation
Panel
Power source
Dimensions 182 mm (H) X 61 mm (W) × 18.5 mm (D)
Power source Two LR03 size batteries
Clock Accuracy ±30 seconds per month (at 25 °C)
CZ-RWSU2N 200 mm (H) × 200 mm (W) × 25 mm (D)
CZ-RWSD2 65 mm (H) × 130 mm (W) × 22 mm (D)
CZ-RWSC3 120 mm (H) × 70 mm (W) × 20 mm (D)
CZ-RWST3N 65 mm (H) × 141 mm (W) × 22.5 mm (D)
16 V DC (Supplied from the terminal strip of the
indoor unit's remote controller)
16 V DC
(Supplied from the terminal strip of the indoor unit's remote controller)
3
(EN)