Connecting The Dvi Fiber Outputs - Stryker 1488 Handbuch

Connecting the DVI Fiber Outputs

Using adjustments or performing procedures differently than
specified below may result in hazardous radiation exposure.
The 1488 HD Camera has the optional upgrade, the fiber output, for model
1488010001. This upgrade contains four laser diodes to transmit a DVI output
over fiberoptic cables.
1. Connect four individual fibers (terminated in Lucent connectors) to the
red (R), green (G), blue (B) and clock (C) laser diodes on the console rear
panel.
2. Connect the four fibers to a compatible fiberoptic DVI receiver.
• The four fibers should be connected to the camera console in the
labeled order: RGBC
• The fibers should be connected to the monitor in one of two
configurations: CBGR (reverse order) or BGRC (R/B switched).
Note: The 1488 HD Camera model 1488010001 is a Class 1 laser product per
IEC 60825-1 and 21 CFR 1040.
EN-16