Night Light - Fox Ultron X3 Betriebsanleitung

• When volume setting is changed, the unit will
beep once, at high tone, at the new volume
setting. There are 8 different volume settings
available.
• When tone setting is changed, the unit will
beep once, at the new tone setting. There
are eight different tone settings available.
In all cases, the nightlight will go out approx 2.5
seconds after the last button press. Note that, as
long as the unit is not switched off, the up/down
rocker switch remains assigned to the last para-
meter selected, i.e. it is not necessary to re-select
volume if volume was the last setting adjusted.
The nightlight will always illuminate to indicate
which setting is being changed, if the up/down
rocker switch is pressed.
Note that, when the unit is switched on, the rocker
is always assigned to volume.
• All settings are retained when unit is switched
off
• Settings can be retained for up to a minute or
so, if the battery is removed
The Ultron is equipped with a low power-drain
electronic nightlight.
• To switch nightlight on - press and hold
"on/select/off" pushbutton and press and
release "up" on rocker switch. Release
"on/select/off" pushbutton within 2 seconds.
The nightlight will illuminate brightly for
approximately 2.5 seconds and will then dim
to a low level.
• To switch nightlight off - press and hold
"on/select/off" pushbutton and press and
release "down" on rocker switch. Release
"on/select/off" pushbutton within 2 seconds.
Note that the nightlight is always switched off, if
the whole unit is switched off.

Night Light