Operation - Fox Ultron X3 Betriebsanleitung

The Ultron operates with a 9 volt PP3 battery. To
fit/replace the battery, turn off prior to replacing,
open the case by sliding the battery cover off at
the rear of the bite alarm. Take care removing
the battery connector, ensure correct polarity and
connection prior to turning back on. The use of a
good quality alkaline battery is recommended to
ensure maximum battery life.
All functions are controlled by the "on/select/off"
pushbutton and the "up/down" rocker switch.
• To switch unit on - press and release the
"on/select/off" pushbutton - unit will beep
once at high tone. Main LED will illuminate
for approx 2.5 seconds
• To switch unit off - press and hold the
"on/select/off" pushbutton for at least 2
seconds. Unit will beep once at low tone and
LED will flash momentarily
• To change volume and tone - press and quickly
release the "on/select/off" pushbutton. The
nightlight will brightly illuminate one of the
following colours, to indicate which parameter
has been selected -
RED
GREEN
Repeatedly pressing the "on/select/off"
pushbutton will change between red and green.
When the correct colour is shown, the setting can
be adjusted, by using the up/down rocker switch.
Battery

Operation

= volume
= tone