SOLAC espression CA 4805 Gebrauchsanleitung Seite 42

9. The coffee machine will stabilise the internal system
temperature automatically. This automatic process lasts
approximately 25 seconds, during which time the water
will be driven through the coffee outlet.
During this time, the light on the steam icon will flash.
10. The coffee machine is now ready to prepare coffee. The
lights on the two coffee extraction selectors will be lit
to indicate that it is ready.
11. Place the cup with milk under the coffee outlet.
12. Pour the coffee directly into the cup to obtain a deli-
cious cappuccino.
15 LIME SCALE REMOVAL
Lime scale should be removed regularly to clean the de-
posits from the internal circuits of the coffee-maker. The
frequency with which your coffee -maker needs to be
cleaned depends on the hardness of the water you use.
Consequently, you first of all need to test the hardness
of the water. To do this, proceed as indicated in section
17 PROGRAMMING YOUR COFFEE-MAKER.
IMPORTANT!! DO NOT USE VINEGAR OR ANY OTHER LIME
SCALE REMOVAL AGENT NOT SUPPLIED BY SOLAC UNDER
ANY CIRCUMSTANCES. You will find a sachet of lime scale
removal agent containing the exact amount for one re-
moval with the accessories to your coffee-maker.
1. The coffee machine will inform you whenever it is neces-
sary to carry out the circuit decalcification process, by
lighting up the orange decalcification icon.
NOTE: The decalcification process lasts approximately 35
minutes, so that it does not have to be carried out when
the coffee machine turns the icon on.
The machine may be damaged if the decalcification proc-
ess is not carried out and coffee is prepared.
2. Enter the programming menu and press the steam and
ground coffee buttons at the same time during one
second. The two icons will light up and the coffee ex-
traction selection buttons will be turned off.
3. Press the warm water and ground coffee buttons at the
same time.
Do not pour water into the tank yet, since you must pre-
pare the decalcification solution first.
12