Care And Cleaning - Kenwood TT720 series Handbuch

to use the warming rack
1 Slot the warming rack into the holes
on top of the toaster
2 Put your food on top of the rack
(slice thick items in half to stop their
outsides burning). Watch to make
sure it doesn't burn, and turn it over
half way through.
3 Press the warming rack button, then
press the carriage button. Both
buttons will glow and the carriage
will lower automatically.
4 During operation the indicator lights
will flash one after the other and after
about 2 ⁄ minutes the carriage will
1
2
rise automatically.
5 To stop the operation at any time
press the carriage button.
6 To remove the warming rack, allow
the toaster to cool and unplug.
7 Lift off the warming rack.
to stop the audible beep
Should you wish to stop the audible
beep that accompanies some of the
toaster operations, hold down the
defrost button for 3 seconds and the
defrost light will go out to
acknowledge the change.
If at any point you wish to re-install
the beep repeat the above
procedure and the toaster will beep
once. However, when the toaster is
unplugged the beep will
automatically be re-installed.

care and cleaning

1 Before cleaning, unplug your toaster
and let it cool down.
2 Slide out the crumb tray
then replace. Do this regularly:
crumbs can smoke or even burn.
3 Wipe the outside of the toaster with
a damp cloth, then dry.
service
●
.
●
●
●
. Clean,
4
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
using your toaster or
servicing or repairs
Contact the shop where you bought
your toaster.