Dea SPACE Bedienungsanleitung Seite 37

3 Transmitters learning
1. Scroll down the parameters with
keys until you visualise P005;
2. Confirm by pressing on the
3. When the symbol " " appears, press on
any key of the transmitter you want to memo-
rize;
4. The display visualizes the number of the trans-
mitter just memorized and then "
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memori-
zation mode, display shows now "P003".
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode by
pressing the hidden button on a remote control
previously learned.
Warning: When using personalized transmitters,
after entering P005 the learning of the first
personalized transmitter is possible only by
pressing its hidden button. Afterwards, only
transmitters personalized with
encryption key can be memorized (through the
usual procedure), unless a memory reset is
carried out (P004).
4 Deletion of all transmitters
1. Scroll down the parameters until you visualize P004;
2. Confirm by pressing on the
3. When " " is flashing, press the
onds;
4. Release the key as soon as "
5. All memorized transmitters have been deleted (display
shows again P004).
5 Programming complete
WARNING At the end of the programming procedure, re-introduce Jumper J4, until "- - - -" is shown on the display and close the lid of
the electric box. The automatism is now in stand-by for normal operating commands.
To perform any "Advanced Programming" operations (parameters modification, programming block/release, configuration of inputs
etc..), go to page 36.
and
key;
";
the same
key;
key for a few sec-
" stops flashing;
35