1.4.2
Remove battery pack
1. Insert the key (A) in the lock (B) (this
key is the same as the key for the
bicycle lock).
2. Lift the top side of the battery pack (C)
using the handle (B).
3. Move the battery pack (C) towards the
headset.
4. Take the battery pack (C) out of the
frame.
* Always remove the battery pack with two hands to prevent the
battery pack from falling.
* Remove the battery pack from the frame when you transport the
bike by car. Use the cover to close off the opening in the lower
frame to prevent ingress of dirt and moisture. If you do not have
this cover, contact your dealer.
1.4.3
Safety
The battery pack can only be used on the bicycle on which it has been
installed. A code in the software makes sure that it cannot be used
on another bicycle, that is to say, there will be no peddling assistance
(protection against theft).
1.4.4
Peddling assistance
You can switch on the system by pressing the up arrow on the lights button.
When the E-bike is not being used, the peddling assistance and lights will
be switched off automatically after five minutes. The display will be put in the
sleep mode automatically after another fifteen minutes and the display will
no longer be shown.
Press the up arrow on the lights button to cancel the sleep mode.
The sleep mode of the display will also be cancelled when the bicycle is
again in motion.
62
62
B
A
C