imacon Flextight Progression Anwenderhandbuch Seite 40

Hardware ReferenceÑFlextight Progression
38
Preparing the Scanner for Transport
more secure for shipping. Your scanner should now be turned on,
but it does not necessarily need to be connected to a computer.
2. If necessary, remove the electrostatic plate as described in ÒRemov-
ing the Electrostatic PlateÓ on page 13.
3. Locate the sheet of bubble plastic that came sandwiched between
the two glass plates when your Þrst unpacked the scanner. Mount
the plastic between the glass plates as described in ÒScanning
Batches and Thick Reßectives with the FlatbedÓ on page 19.
4. Replace the electrostatic plate as described in ÒReplacing the Elec-
trostatic PlateÓ on page 14.
5. Press the drawer button (shown in Figure 1). The ßatbed drawer is
drawn back into the scanner.
6. Locate the cardboard drawer-securing plate that came with the
scanner. It is shown in Figure 13.
7. As shown in Figure 13, insert the tab of the cardboard drawer-
securing plate into the handle and press the top part between the
ßatbed and the scanner. The space between the ßatbed and the
scanner is very narrow and makes a tight Þt with the cardboard.
You may need to press down slightly on the ßatbed in order to Þt
the cardboard in.
8. Press the drawer support all the way into the scanner so that it is
ßush with the ßatbed.
Imacon Flextight Progression UserÕs Guide