Removing And Replacing The Electrostatic Plate; Removing The Electrostatic Plate - imacon Flextight Progression Anwenderhandbuch

Þtted with a terminator. If your chain is not terminated, your com-
puter system may not work properly.
7. Plug the power cable into the standard power socket on the back of
the scanner.
8. IMPORTANT: Make sure that the wall socket you are planning to
use meets the electrical requirements outlined in ÒElectrical
RequirementsÓ on page 11.
9. Plug the other end of the power cord into a compatible wall socket.
10. Press the rear power switch to apply power to the scanner (it is
located at the back of the scanner as shown in Figure 3). This places
the scanner in standby mode.
11. Press the power button on the front panel (shown in Figure 1) to
turn on the scanner. The green light starts ßashing. This means that
no Þrmware has been downloaded yet. It will be downloaded auto-
matically later when you Þrst run the ColorFlex software.
12. Your system is assembled. Turn on your computer and install the
ColorFlex image scanning software.

Removing and Replacing the Electrostatic Plate

Remove the electrostatic plate in the ßatbed drawer only when you
want to use the batch-transparency or thick-original scanning features.
WARNING: Do not fold or bend the electrostatic plate. It contains sen-
sitive electronic components that may be destroyed if stressed.

Removing the Electrostatic Plate

1. Pull out the ßatbed support as far as it will go by pulling on the
drawer support handle shown in Figure 2.
2. Press the drawer button (shown in Figure 1). The ßatbed drawer
opens automatically.
IMPORTANT: if a problem occurs when the drawer is opening
(such as an obstruction), you can stop the drawer by pressing the
drawer button again.
Imacon Flextight Progression UserÕs Guide
Hardware ReferenceÑFlextight Progression
Removing and Replacing the Electrostatic Plate
13