imacon Flextight Progression Anwenderhandbuch Seite 20

Hardware ReferenceÑFlextight Progression
18
Operating Instructions
4. Position your original (or originals) on the electrostatic plate, using
the printed markings as a guide. Note that by placing your origi-
nals along the center of the plate, you will be able to use the highest
possible resolution setting, which is dependent on the width of
your original (see Figure 7).
Figure 7:
5. Press the electrostatic Þeld button (shown in Figure 2). Your origi-
nals will be ÒsuckedÓ into place.
6. Go to your computer and run the scanning software. Follow the
directions given in the ColorFlex software manual to set the origi-
nal format, take a preview, make settings, and take the Þnal scan.
7. When you have Þnished scanning, remove your original and press
the drawer button again. The top layer of the ßatbed drawer is
automatically drawn back into the scanner, leaving the drawer sup-
port extended. Gently press the drawer support into the scanner.
Align originals
along the
center of the
ßatbed. Nar-
row originals
can be scanned
at higher resolutions.
Aligning originals on the ßatbed
Imacon Flextight Progression UserÕs Guide