Installation; Maintenance; Intended Use; Environmental Conditions - OHAUS HSMNHP4CAL Bedienungsanleitung

INSTALLATION

Upon receiving the Ohaus Mini Hotplate/Stirrer/Hotplate-Stirrer check to ensure that
no damage has occurred in shipment. It is important that any damage that occurred in
transport is detected at the time of unpacking. If you do find such damage the carrier
must be notified immediately.
After unpacking, place the Mini Hotplate/Stirrer/Hotplate-Stirrer on a level bench or
table, away from explosive vapors. Ensure that the surface on which the unit is placed
will withstand typical heat produced by the unit and place the unit a minimum of six (6)
inches from vertical surfaces. Always place the unit on a sturdy work surface.
The Mini Hotplate/Stirrer/Hotplate-Stirrer is supplied with a 3-prong power cord that
should be plugged into a standard 3-prong grounded outlet. If the cord supplied does
not meet your needs, please use an approved power cord that suits local codes and
electric supply. Replacement of the plug must be made by a qualified electrician.

MAINTENANCE

The Mini Hotplate/Stirrer/Hotplate-Stirrer is built for long, trouble-free, dependable
service. No lubrication or other technical user maintenance is required. It needs no
user maintenance beyond keeping the surfaces clean. The unit should be given the
care normally required for any electrical appliance. Avoid wetting or unnecessary
exposure to fumes. Spills should be removed promptly after the unit has cooled down.
Do not use a cleaning agent or solvent on the front panel which is abrasive or harmful
to plastics, nor one which is flammable. Always ensure the power is disconnected from
the unit prior to any cleaning. If the unit ever requires service, contact your Ohaus
representative.

INTENDED USE

The Ohaus Mini Hotplate Stirrers are intended for general laboratory use. Safety can
not be guaranteed if used outside of the intended use.

ENVIRONMENTAL CONDITIONS

Operating Conditions: Indoor use only.
Temperature: 5 to 40°C (41 to 104°F)
Humidity: 20% to 85% relative humidity, non-condensing
Altitude: 0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: 20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.

EQUIPMENT DISPOSAL

This equipment must not be disposed of with unsorted waste. It is your
responsibility to correctly dispose of the equipment at life-cycle-end by
handing it over to an authorized facility for separate collection and recycling.
It is also your responsibility to decontaminate the equipment in case of
biological, chemical and/or radiological contamination, so as to protect the
persons involved in the disposal and recycling of the equipment from health
hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure that
your equipment is recycled in a manner that protects human health.
EN
2