Carbon Filter - Atag WO6111BM Anleitung

MAINTENANCE
2
1

Carbon filter

1 2
3
1. Push the projections at the back of the filter into the openings
provided for this purpose at the rear of the extractor hood.
2. Hinge the filter upwards.
3. Release the locking mechanism. The projections at the front of the
filter move outwards into the openings provided for this purpose at
the front of the extractor hood.
The filter is now correctly positioned.
If you plan to use the appliance as a recirculation hood, you must
first install the carbon filter. In the case of normal use the carbon filter
must be replaced three times annually. In the case of intensive use the
carbon filter should be replaced more frequently.
Installing / replacing
1. Remove the grease filters.
2. Make sure the internal Extraction/Recirculation mode switch is set
to "Recirculation".
3. Position the charcoal filter covering the grille so that the slots (S) on
the filter are aligned with the fixing pins (R).
4. Press down on the filter and turn it in a clockwise direction until it is
fixed in place (bayonet fastening).
5. Replace the grease filters.
extraction
recirculation
EN 9