Removing The Grease Filters; Replacing The Carbon Filter - Atag WS9111EM Anleitung

MAINTENANCE
Grease filters
Carbon filter
Bulbs
GB 10
Removing grease filters
Switch off the main Voltage! Remove the plug from the socket or turn
the switch in the meter box to zero. Pull the filter towards you and tilt it
down and forwards.

Replacing the carbon filter

Use a carbon filter if the extractor fan is not connected to an exhaust
duct.
1. Remove the grease filters
2. Install the carbon filters
3. Install the grease filters.
Important:
• The saturation of the filter depends on the intensity of use, the
cooking method and the regularity with which the grease filters are
cleaned.
• The carbon filter must be replaced a minimum of every four months.
• Carbon filters cannot be washed for re-use. Saturated carbon is not
environmentally friendly. Replace the filter in time.
Replacing bulbs (WS9111EM/WS9111EX/WS9192EM)
• Remove the cover from the bulb
• Replace the halogen bulb with a new bulb of a maximum of 20
Watts.
• Install the cover again.
Replacing bulbs (WS6011IM/WS9011IM/WS1211IM)
• Gently press the front side of the window (A) and it should tilt open
slightly.
• Open the window fully and fit a new 20 W halogen bulb (A).
Note: do not touch the bulb's glass with your fingers.
• Gently push the window closed again.