Grease Filters - Atag WO6111BM Anleitung

MAINTENANCE

Grease filters

1
2
EN 8
Clean the grease filters at least once a month. During cleaning, the
aluminium parts of the filters may become dull as a result of the
cleaning agents used, particularly when placed in the dishwasher. This
is normal and is not covered by the warranty.
A
Removing aluminium grease filter
1. 1 Switch off the flap and lighting.
2. 2 Unlock the grille (A) and hinge it downwards.
3. 3 Push the wire brackets aside.
4. 4 Remove the grease filter from the grille.
1 2 3
Removing filter cassette
1. Switch off the flap and lighting.
2. Using the recess, press the filter backwards and tip it downwards
at the front.
3. Remove the filter from the hood.
Cleaning
• You can clean the filters in the dishwasher. Allow them to drain fully
before reinstalling them in the hood.
• The filters may also be cleaned by hand. Clean the filters in water
and washing-up liquid and rinse them. Allow the filters to drain fully.
The underside of the extractor hood can be cleaned with a mild
cleaning agent and a moist cloth. Then dry it off with kitchen towel
or a dry cloth.
Reinstalling the aluminium grease filter
1. Place the filter in the grille.
2. 2Refit the wire brackets.
3. Place the grille back in the extractor hood. First press the back into
the hood; then the front. The filter will now click into place.
A
4. Lock the filter in place by pushing the locking projections outwards.
Reinstalling filter cassette
The filter has to be installed with the locking mechanism at the front.
Open the locking mechanism. This pulls the projections at the front of
the filter inwards. When installing the filters hold the locking mechanism
in this position.