Sanding Cuts And Sandpaper - Clarke American Sanders Super E Edger Handbuch

ENGLISH
EN

SANDING CUTS AND SANDPAPER

Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. A coarse abrasive should be used.
If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this should occur during an
initial cut, the abrasive has dulled and must be replaced.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60 - 80 grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive (80 - 100 grit). Care
should be taken in selecting the grit size of the abrasive. A very fi ne grain will close the pores on a wood fl oor making admission of
a stain diffi cult.
Grain Use
12 grit For removing gross imperfections and
16 grit restore evenness to old fl ooring. To remove
20 grit build-up of paints and varnishes.
24 grit
30 grit For fi rst sanding of new fl ooring (maple, oak).
36 grit For removing minor imperfections and fi nishes
from old fl ooring.
40 grit For initial cut on new fl ooring (oak, walnut).
For removing minor imperfections and fi nishes
from old fl ooring.
50 grit For fi rst sanding of new fl ooring (cedar, pine,
fi r) For clean-up of 16 grit.
60 grit For clean-up from initial cut 36 grit.
80 grit For fi nal sanding of certain hardwoods. For
clean-up of initial cuts (50 grit).
100 grit For fi nal sanding of certain hardwoods and
conifers where a smooth surface is desired.
120 grit For fi nal sanding of certain conifers.
150 grit For fi nal sanding of certain conifers where a
smooth surface is desired for surface
roughening between coats of fi nish.
-6- FORM NO. 70102B
7" Diameter 7" Diameter
Standard Grade Professional Grade
Part #/Qty
945300/50 945594/200
945301/50 945595/200
945302/50 945596/200
945597/300
945598/300
945305/100 945599/300
945600/300
945307/100 945601/300
945308/100 945602/300
945309/100 945603/300
945310/100 945604/300
945605/500
945606/300
American Sanders Operator's Manual (EN) - Super E
®
Clarke
5" Diameter
Standard Grade
Part #/Qty
Part #/Qty
945314/50
945315/50
945316/50
94319/100
94321/100
945322/100
945323/100
945324/100
5" Diameter
Professional Grade
Part #/Qty
945701/250
945702/250
945703/250
945704/500
945705/500
945706/500
945707/500
945708/500
945709/500
945710/500