Included In Delivery; Start-Up; Power Supply; Operation - Silvercrest SEC 60 A1 Bedienungsanleitung

with various varnishes and plastics
and may be treated with different
cleaning products, it cannot be com-
pletely ruled out that some of these
substances contain components which
may attack and soften the silicone
feet. If necessary, place an anti-slip
mat under the appliance.
• Do not use any aggressive or abrasive
cleaners.
• Clean all the accessories of the ice
crusher by hand. They are not suited
for the dishwasher.
2.

Included in Delivery

1 Ice crusher
1 Lid 1
1 Collecting container 6
1 Ice scoop 5
1 Operating instructions
3.

Start-up

DANGER! The knives of the
crushing mill are sharp. Do not
reach into the crushing mill
through the filler shaft.
1. Remove all packaging material.
2. Check whether all accessories were
included and are undamaged (see
"Included in Delivery" on page 27).
3. Clean all accessories as described in
these instructions (see "Cleaning" on
page 28).
4. Place the ice crusher on a dry, level
and anti-slip surface.
4.

Power supply

DANGER! Only connect the de-
vice to an easily accessible outlet,
the voltage of which complies with
the information on the type label.
Even after connecting the power
plug, the outlet must be easily ac-
cessible.
• Unplug the power plug from the socket
after every operation.
5.

Operation

DANGER! Never reach into the
running device through the filler
shaft. Do not insert any items into
the filler shaft. Also hold long hair
or loose clothing away from the
filler shaft. There is a risk of injury
due to the rotating knives of the
crushing mill.
WARNING!
• Let the device cool down for at least
2 minutes after each operation.
• To prevent damages to the device,
immediately interrupt the crushing
operation as soon as the knives do not
turn or only turn with difficulty. Turn the
device off immediately and pull the
power plug. Check whether there is
too much ice in the crushing mill.
Should that be the case, wait until the
ice in the filler shaft has melted.
1. Switch the ice crusher on with the On/
Off switch 7 and let the device run for
a few seconds.
2. Remove the lid 1.
3. Place one ice cube on top of the filler
shaft flap 2.
27
GB