Inhaltsverzeichnis
Werbung
3. Press OK. The table with languages will appear on the screen.
4. Use the P+ or P- to select the language you require.
5. Press the MENU key two times to switch off the Setup menu.
Adjusting the picture
1. Press the MENU key on the remote control. The Picture menu will
appear on the screen. The required picture parameter you can select
by using remote control keys P+, P-, and to change value of this
parameter by using keys VOL+, VOL-.
Tuning your television set
You can tune your television set in two ways: automatically or manually. The automatic tuning is
completed in the following way:
1. Press MENU key two times. The Install menu will appear on the
screen.
2. Using the remote control keys P+ or P- select line Auto Tune.
3. Press OK. Your TV will now automatically tune and store all your local
TV stations. This will take a few minutes. On completion of automatic
tuning the first programme is automatically shown on the screen and
you can select the desired programme by using the remote control
buttons P+, P-, 0, 1, ..., 9 or front panel buttons P+, P-.
4. For labelling, moving or hiding of tuned programmes you can use the
menu Organize. Usage of this menu is described in page 18.
Notes:
1. For better picture quality your VCR or satellite receiver should be connected to SCART
socket on your TV set.
2. If you do not use the SCART socket, for receiving VCR signal via aerial socket a programme
with number 99 is recommended.
Hrvatski
Slovensko
Deutsch
Rumanian
Polski
Lithuanian
Èestina
Sloven
ina
è
Magyar
Bulgarian
Russian
English
Picture
Brightness
Contrast
Colour
Sharpness
Install
Auto Tune
Manual Tune
Fine Tune
Store
16
The required outer signal source you can select by pressing the AV key on the remote control
(depending to the model).
AV
Selects video and audio inputs on the SCART connectors. Used for direct
connection of VCR, satellite receiver, etc.
RGB
Selects red, green and blue signal inputs on the SCART connector. Used for
the direct connection of game machines and other equipment.
20
21
Quick start guide
1. Install two batteries into the remote control according to the diagram inside the battery
compartment.
2. Plug your aerial into the aerial socket of TV set.
3. Plug your TV power lead into the mains socket and press
screen of TV does not light, press the P+, P- key or 0, 1, ..., 9 key on the remote control,
or use P+, P- keys on the front panel to switch the TV set from standby to ON.
4. Press the MENU key on the remote control 2 times. The Install menu will appear on the
screen.
5. Press OK. Your TV set will now automatically tune and store all TV programs. This may take
a few minutes. On completion the first programme will appear on the screen.
6. You can move programmes to the desired positions by using menu Organize now (see
"Customizing your stored programmes").
7. Select the desired programme by using the P+, P- or 0, 1, ..., 9 keys on the remote control
or the P+, P- keys on the front panel.
Notes:
1. When there is no signal ion the aerial socket, the screen of TV set is blue.
2. If notes that are not described in this instruction appears on TV screen (because of external
disturbances), press the PP on the remote control. The TV set will switch to usual operating
mode.
3. Please note that in some receiving areas (like Berlin/Brandenburg) the analog antenna signal
has changed to the digital antenna signal. So you can receive the TV-signal via terrestric
antenna only with a DVB-T Receiver.
AV modes
2
1
button on the front panel. If
21
Werbung
Inhaltsverzeichnis
