Inhaltsverzeichnis
Werbung
Using Teletext (Teletext models only)
1. Use the remote control to select a programme with Teletext information.
2. Switch on the Teletext by pressing TV/TXT.
3. Using the 0, 1, ..., 9 keys on the remote control enter page number (3 digits). Your TV set
will search for the indicated Teletext page. After moment the Teletext page will appear on
the TV screen.
Page number
199
Red
Page numbers in coloured rectangulars will appear at bottom of the screen. You can select these pages
by pressing corresponding coloured buttons.
4. To return to the normal TV picture, press the TV/TXT key.
Notes:
1. If TV station does not broadcast Teletext information, so after switching Teletext on, a black
line with page number appear in the top of the screen.
2. The control of Teletext by using other buttons is described in the chapter "Functions of
remote control".
3. Sound level not are adjustable when teletext function are on.
Teletext information
Green
Yellow
Blue
22
Switching on
1. Remove the battery cover from the remote control unit and install two AAA type batteries
(not supplied) according to the diagram inside the battery compartment. Replace the battery
cover.
Attention: Please ensure that the polarity of the batteries is correct. Batteries are not to be disposed
of together with domestic wastes. Dispose of the used batteries at the relevant collection
bin or at your dialers. Never throw batteries into the fire.
2. Connect your aerial to the TV set.
3. Connect your TV to a 230 VAC power socket.
4. Switch on your TV with the
switch on the front panel. The red light will be illuminated. If
the screen does not light up, press a button P- or P+ on the front of the television set or any
of the keys P-, P+, 0, 1, ..., 9 on the remote control.
Notes:
1. After switching the television set on by using
same mode it was before switching of by this button. If TV set was switched off by using
the remote control key POWER, it switches to standby and the indicator on the front panel
turns red.
2. After switching television set from standby to operating status, the red indicator go down.
Control of TV set by using MENU tables
Your television set is controlled by using MENU tables Picture,
Install, Setup. These tables appear on the screen after pressing
remote control button MENU one or more times. The television set
parameters and their values are arranged in these MENU tables.
The line of table with required parameter you can select by using the
remote control keys P+ or P-, and to change this parameter by using
keys VOL+ or VOL-. MENU tables from the TV screen disappears
after pressing the remote control key MENU one or several times or
about after 5 seconds after the last action in these tables.
Note:
The selected line in table is highlighted in red.
Selecting the menu language
The on-screen menu has several languages. The selection of language is the following:
1. Press the MENU key on the remote control 3 times. The menu Setup
will appear on the screen.
2. Use the P+ or P- to select Language.
front panel button, the set switches to the
Setup
Timer
Organize
Function
Language
Hrvatski
Slovensko
Deutsch
Rumanian
Polski
Lithuanian
Èestina
Sloven
ina
è
Magyar
Bulgarian
Russian
English
Setup
Timer
Organize
Function
Language
15
Werbung
Inhaltsverzeichnis
