Radio Operation; Switching Off - Clatronic TV 486 Bedienungsanleitung

5....-05-TV 486 DK
1. Turn the TV/OFF/RADIO switch (located on the right-hand side of the television
set) to the RADIO position.
2. Pull out the telescopic aerial as far as it will go and turn it until you receive the
best possible reception.
3. Push the FM-VHF-LOW/HIGH/AM-UHF switch on the right-hand side of the
television set to the desired band range: AM = MW, FM = UKW.
4. Use the TUNING control located on the right-hand side of the television set to
tune in to the desired station.
NOTE: The reception may be impaired through poor reception locations or thick
building insulation, etc! Try to optimise reception by turning the aerial. If necessary,
move the television set to another position.
You can adjust the volume to your requirements with the VOLUME regulator on the
right-hand side of the television set.
• Turn the TV/OFF/RADIO switch located on the right-hand side of the television
set to the OFF position. The television set is now switched off.
• Remove the mains adapter from the socket or the car adapter from the cigarette
lighter.
On the back of the television set are located various input and output sockets:
ANT: For the connection of an external antenna. Requires a 3.5 mm jack adap-
ter.
PHONE: For the connection of headphones with a 3.5 mm jack plug. If the sound
can only be heard on one side of headphones, use a stereo-mono adap-
ter!
VIDEO: For the connection of the video signal (picture signal), e.g. from a video
recorder via a chinch connection (not included).
AUDIO: For the connection of the sound signal, for example from a video recorder
via a chinch connection (not included).
• Always switch the machine off before cleaning it (TV/OFF/RADIO switch in the
OFF position).
• Clean the outside of the housing with a slightly damp cloth (not wet!), without
any additional agents!
16.10.2002 8:36 Uhr

Radio Operation

Switching Off

Input/Output Sockets
Cleaning
Seite 17
17
GB