Christie LX1750 Netzwerkinstallation Und Betrieb Seite 52

3. When communication is established correctly, the word "PASSWORD:" appears on the
window. Type the login password (Network PIN code
"Enter" key. If you do not set up the Network PIN code, just press "Enter" key.
When the word "Hello" appears, login has been succeeded.
* The password "1234" is used for the example.
4. Type the commands, refer to below table, to control the projector and then press "Enter"
key for termination. For example, type "C00" which is a command to turn on the projec-
tor, and press "Enter" key. Confirm the projector is turning on.
Enter with ASCII 64-byte capital characters and one-byte characters.
*
To disconnect the communication, press "Ctrl" key and "]" key at the same time, type
"close" and then press "Enter" key on the Keyboard.
> close [return]
The table below shows the typical command lists for controlling this projector and please
consult your local dealer for further information of another commands.
*1 For further instructions about the telnet application, please see the on-line guide on your com-
puter.
*2 The password is a Network PIN code decided item "Network PIN code setting" (
authentication of the entered password fails 4 times continuously, the communication will be dis-
connected automatically. Please try again for the connection.
If the password or any command is not entered for more than 30 seconds, the communication will
✐
be disconnected automatically. Please try again for the connection.
LX1750 Network User Manual
020-000639-01 Rev.1 (11-2013)
Command list table
Command Function
C00 Power on
C01 Power off
C05 Input 1
C06 Input 2
C07 Input 3
C08 Input 4
C1C Menu display on
C1D Menu display off
) for the projector and then press
*2
pp.14, 23). If the
+
Use of telnet
51