Maintenance - Whale Twist Montageanleitung

STEP 2. ATTACH P CLAMP TO BULKHEAD
Screw p clamp to bulkhead ensuring it is located
at least 300 mm (12") from the valve housing
(See Fig. 14)
N.B. In order to securely fasten the unit, ensure
that the p clamp mounting surface is at least
19mm ( 3 / ") minimum thickness.
4
STEP 3.
Close all the faucets and showers, turn on the
water pump and check all the connections are dry.
Test Whale Twist TM operation (See section 10.)

9 MAINTENANCE

For all Whale Twist TM models
Clean housing and handset with warm
soapy water.
Do not use any chemical cleaning agents.
Regular inspection of plumbing connections and
tubing is recommended.
FOR MIXER MODELS
If you need to remove the handset and hose for
replacement, remove the unit at the valve housing
and insert the temporary shut off valve as shown.
(See Fig. 16a, 16b and 16c)
This allows you to use the freshwater system until
the new hose is installed.
Fig 16 a
Fig 16 b
Fig 16 c
EN
15