Whale Twist Montageanleitung Seite 13

8 PLUMBING
PLUMBING PREPARATION
STEP 1. Turn off electrics, open all faucets and
showers (hot and cold) to depressurize the
system and remove the existing shower.
STEP 2. Prepare hot and cold plumbing lines to
have appropriate connections to
valve housing ports (See Fig. 13a).
PLUMBING - MIXER MODELS
(Product codes: DS0003B, DS0004B, DS0013B,
DS0014B, DS0413B, DS0414B DS0006).
STEP 1.
Secure the valve housing using a number 2 pozi
screwdriver to tighten the screws provided.
N.B. The valve should be installed as close to the housing
as possible. Space must also be allowed for the handset
hose to be easily pulled out for showering and replaced for
stowage (See Fig. 2/Fig. 7).
N.B. In order to securely fasten the unit, ensure that the
valve mounting surface is a minimum thickness of
19mm ( 3 / ").
4
STEP 2.
Connect hot and cold plumbing into
threaded ports.
If attaching to Whale Quick Connect plumbing
fittings, use two WX1532B fittings (provided in
retail packed models only, available separately
for bulk packed models). (See Fig. 13a and b)
Fig 13a
1 / " threaded
2
Fig 13b
1 / "
2
Behind the
Hot
Bulkhead
Cold
Hot
Behind the
Bulkhead
Cold
EN
1 / " threaded ports
2
13