Installation Of The Outdoor Unit; Outdoor Unit Sl Series Clearance (In Mm); Refrigerant Piping - Acson international CC 15C Installationsanleitung

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

The outdoor unit must be installed such that there is no short

circuit of the discharge air or obstruction to smooth air flow.

Respect the installation clearance. Select the coolest possible

place where intake air should not be higher than the outside

temperature (maximum 45°C).

Ensure that there are no obstruction of air flow into or out

of the unit. Remove obstacles which block air intake or

discharge.

The location must be well-ventilated, so that the unit can

draw in and distribute plenty of air thus lowering the

temperature.

A place capable of bearing the weight of the outdoor unit as

well as isolating noise and vibration.

A place protected from the direct sunlight. Use an

awning for protection if necessary.

The installation location must not be susceptible to highly

concentrated dust, oil, salt or sulfide gas.

Maximum Pipe Length And Maximum Number Of

Bends

When the pipe length becomes too long, both the capacity

and reliability drop. As the number of bends increases,

system piping resistance to the refrigerant flow increases,

thus lowering the cooling capacity. As a result, compressor

reliability will be affected. Always choose the shortest path

and follow the recommendation as tabulated below:

Model

Data

Maximum Length, A m (ft)

Maximum Elevation, B m (ft)

Maximum No. of Bends, C

Model

Data

Maximum Length, A m (ft)

Maximum Elevation, B m (ft)

Maximum No. of Bends, C

Remark : For CC60C cooling unit, recommended to add

6 kg external accumulator.