Programming The Device For The Staple Process; Programming The Device For The Welding Tip; Standby Mode; Resumption Of Work - Mixplast Magic Stapler Gewährleistung Und Gebrauchsanweisung

Standby and resumption of work:

► standby mode

The Magic Stapler will enter into standby mode following 25 seconds of inactiviy.
Before entering standby mode, the Magic Stapler will record in its EEPROM the level of current and the mode prior to standby
(LED light ON or OFF)

► resumption of work

repowering the magic stapler can by done by pressing the either trigger (rep5) or one of the up/down buttons (rep9).
Welding process:
Before carrying out the process, please ensure that you have adhered to all rules that are in force. In order to guarantee quality during
the process and to preserve the original resistance properties as best as possible, we advise you to comply with all the rules stated in
the paragraph below, titled ''procedure''.
Procedure:

►Programming the device for the staple process:

Adjust the current from 1 to 4 according to the type of staple (see Power settings table below) using buttons rep9 and
Position the staple onto the electrodes (rep.2) according to the appropriate angle 45°- 90° or 180°
Position the staple onto the material for welding and press and hold in the on-off switch (Rep5). Exerting a tiny bit of pressure, press
the staple down and hold in position until fully inserted into the material.
Wait a few seconds for the staple to cool before retracting the stapler and continue the process as required.
►Programming the device for the welding tip function:
adjust the current from 5 to 6 according to the type of welding tip using buttons rep9 + and - (see Power setting table below)
Clip the welding tip (Rep11) onto the electrodes (Rep2.)
Press and hold the power button (Rep5) to heat the welding tip and carry out the welding process.
Power setting based on staples and tools used
lEVEL LED
1 1 Fixed
2 2 Fixed
3 3 Fixed
4 4 Fixed
5 5 Fixed
6 6 Fixed
Should you have any questions, please do not hesitate to contact us via email: mixplast@mix.fr
Type
staples: 3641-6 / 3642-6 / 3643-6 / 3649-6 / 3658-6 / 3668-6
staples: 3641-8 / 3642-8 / 3643-8 / 3649-8
staples: 3658-8 / 3668-8 / 3649-9
staple: 3645-9
Welding tip 3644-u
Welding tip 3644-o
Page 3
+ and -.