Troubleshooting - Epson HDBaseT ELPHD01 Bedienungsanleitung

Troubleshooting

Problem
No images appear Is the power on?
The image is
blurred
No HDMI audio is
output
Solution
Check that the Power indicator is green.
Is the HDMI cable connected correctly?
Check that the HDMI cable is securely connected to
the connectors on the video equipment and this device.
Is the LAN cable connected correctly?
Check that the Link indicator is green. Also, make sure
you are using a category 5e or category 6 straight STP
cable.
Is the HDMI device turned on?
Check that the HDMI device is turned on and that an
image is being played back.
Was a cable connected during operation?
Connect all necessary cables before turning on this
device.
If an image is still not displayed even after checking the
points above, try turning the power off and then back
on for all connected devices.
Is the LAN cable connected correctly?
Check that the Link indicator is green. Also, make sure
you are using a category 5e or category 6 straight STP
cable. Do not use a UTP cable.
Is the earth wire grounded?
To perform stable communication with the projector,
make sure the device is grounded.
Is the LAN cable tied to other cables?
If the LAN cable is tied to any other cables, noise may
occur.
Is an HDMI cable being used to connect the devices?
If no audio is output when connecting via an HDMI
cable, set the connected equipment to PCM output.
19