Epson HDBaseT ELPHD01 Bedienungsanleitung Seite 18

f Power inlet
g [Sleep Mode]
switch
h Wired-IR In port
i Link indicator
j HDBaseT port
k FG connector
(earth)
Supported LAN Cables
Use a category 5e or category 6 straight STP cable. When using a cable,
use a tester to check that the cable's properties are at least category 5e
before connecting. When using a relay connector, make sure the connecting
cables meet the specifications mentioned above.
Connects the AC adapter's power plug.
Do not use a different power supply (AC adapter/
power cable). Only use the one supplied.
Note that when the power cable is plugged in, this
device turns on automatically (Direct Power On)
when power is restored after a power outage.
When set to [Enable], the device automatically
enters sleep mode and turns off after 30 minutes
if no signals are input. Press the power button to
turn the device back on.
When set to [Disable], the device does not turn
off automatically. When monitoring and
controlling using HDBaseT, set this to [Disable]
so that the device does not enter sleep mode.
If the device is connected to an access point over
a LAN connection, it will not turn off even when
sleep mode is enabled.
Connects the projector's optional remote control
cable set (ELPKC28) and inputs signals from the
remote control.
Turns green when communicating with the
projector.
Allows the device to connect to a projector using
a LAN cable.
Grounds the earth wire.
18