Controlled By The Unit - Panasonic AW-RP50E Bedienungsanleitung

Connections
 Changing the IP addresses 
of the camera numbers

controlled by the unit

Use the steps below when connecting the remote
cameras (thorough a router) whose IP addresses
cannot be set by following the steps in "Auto IP
setting".
 Setting the IP addresses 
On the [SYSTEM] menu, select [CAM IP ADR], and
display [IP:CAM1] to [IP:CAM100]. The IP addresses
of the camera numbers can now be changed.
Even when "NoAsign" or "Serial" has been selected
as the [CAM1] to [CAM100] setting of [CAMERA CTL]
on the [SYSTEM] menu, the IP addresses can still be
changed.
1 . I P : C A M1
1 9 2 . 1 6 8 .0 0 0. 10 0
The IP addresses are set for all the camera numbers
[CAM1] to [CAM100].
Initial values:
CAM1 (192.168.000.010)

CAM100 (192.168.000.109)
 Memo 
If the unit's IP address has been changed using the
[IP ADDRESS] item of [NETWORK] on the [SYSTEM]
menu, the IP addresses of the camera numbers which
were set to "NoAsign" for the [CAM1] to [CAM100]
item of [CAMERA CTL] on the [SYSTEM] menu and
which are higher than the unit's IP address, will be
automatically re-set in the sequence of the camera
numbers set to "NoAsign" starting with the lowest
number.
When the IP addresses are changed, a check for IP
address duplication is conducted.
A check is carried out to verify whether there is any
duplication with the IP addresses of the camera
numbers which were set to "Network" for the [CAM1]
to [CAM100] item of [CAMERA CTL] on the [SYSTEM]
menu.
If duplication is found, "IP Duplicate!" is displayed for
three seconds, and the IP addresses are set.
  The IP addresses set by following these steps
▼
  If there is any duplication among the IP
33 (E)
1. I P : CA M 1
I P D u p li c a te !
Notes
are the IP address of the camera numbers
controlled by the unit.
The IP addresses of the remote cameras are not
changed.
addresses in "Auto IP setting", "IP Duplication!" is
displayed, and the IP addresses will not be set,
but the addresses will be set by performing this
operation.