Panasonic AW-RP50E Bedienungsanleitung Seite 20

Network settings
Setting the IP address
On the [SYSTEM] menu, select the [NETWORK]
menu, and display [IP ADDRESS].
Then operate the F2 dial to set the IP address.
Select a setting which will not duplicate the IP setting
of another device.
1. I P AD D R E S S
19 2 1 68 . 0 0 0 . 00 9
If the same IP address is used more than once, the
"IP Duplicate!" message is displayed on the LCD
panel.
1 . I P A D DR E SS
I P D u p l ic a te !
If the IP address is incorrect, the following message is
displayed on the LCD panel.
U n a v a i l ab l e
n e t w o r k s e tt in g
Notes
  In order for the setting to take effect, the unit
must be restarted.
Turn off the unit's power, and then turn it back
on again.
  Consult the network administrator before setting
the IP address.
On the [SYSTEM] menu, select the [NETWORK] menu,
and display [SUBNETMASK].
Then operate the F2 dial to set the subnet mask.
▼
If the subnet mask is incorrect, the following message
is displayed on the LCD panel.
▼
In order for the setting to take effect, the unit must
be restarted.
Turn off the unit's power, and then turn it back on
again.
On the [SYSTEM] menu, select the [NETWORK]
menu, and display [GATEWAY].
Then operate the F2 dial to set the gateway.
If the default gateway is incorrect, the following
message is displayed on the LCD panel.
In order for the setting to take effect, the unit must
be restarted.
Turn off the unit's power, and then turn it back on
again.
19 (E)
Setting the subnet mask
2.SUBNETMASK
255 255.255.000
Un a v a il a b le
ne t w o rk s et t i ng
Note
Setting the default gateway
3. G A T EW A Y
19 2 1 68 . 0 00 . 0 01
Un a v a il a b le
ne t w o rk s et t i ng
Note