General Technical Data; Wall Mounting - Dražice To 5 In Bedienungsanleitung

4. GENERAL TECHNICAL DATA

Type
Capacity
Rated pressure
Weight
Power in put
Time of rating from 10° to 60°C
Electric connection
IP Protection
Heat losses /energy efficiency class
5. OPERATING ACTIVITY
After the heater is connected to electric network, the heating element starts heating water. The element is
turned on and off by a thermostat.
Thermostat can be set as per your need within the range from 5°C to 75°C. We recommend setting service
water to max temperature of 55°C. This temperature ensures the optimal operation of the heater. After
reaching the temperature set, the thermostat switches off the electric circuit and discontinues water
heating. The control light signals if the element is in operation (light is on) or if it is off (the light goes out).
In case of longer operation without using the heated volume the thermostat has to be
set to position 9°C (set the "snowflake" symbol on the thermostat button) to avoid its
freezing.

6. WALL MOUNTING

Prior to mounting check the loading capacity of the wall. If needed, reinforce it. Mount the water heater in
vertical position only. The fastening screws must have guaranteed spacing of 140 mm. Mounting
dimensions are specified on Fig. 1.
TO 5 IN/UP
l 5
MPa 0,6
kg 7
W 2000
min 9
1 PE-N
V
230V/50HZ
IP 24
kWh/24h
TO 10 IN/UP TO 15 IN/UP
10 15
0,6 0,6
8 11
2000 2000
18 27
1 PE-N 1 PE-N
230V/50HZ 230V/50HZ
IP 24 IP 24
- 27 -