Auto Function - Pioneer PDA-5002 Bedienungsanleitung

AUTO FUNCTION

The plasma display is equipped with an AUTO FUNCTION
detection function; when a signal is detected at the
selected input, the function selector automatically
switches to that input.
1
Press MENU;
The onscreen menu will be displayed.
MAIN MENU
PICTURE SCREEN
:
CO NT RA S T
:
BR I GHT .
: 6
R L E V E L . +
: 6 0
+
G L E V E L .
: 6 0 +
B L E V E L .
:
H E NH AN CE .
:
V E NH AN CE .
R S E T E
SELECT
SET
2
Press 2/3 to select OPTION.
MAIN MENU
PICTURE SCREEN
POWE R
A U T O F
A UD I O O
SELECT
SET
3 Press 5/∞ to select AUTO FUNCTION.
MAIN MENU
PICTURE SCREEN
POWE R
A U T O F
A UD I O O
SELECT
SET
INPUT1
SET UP OPTION
0
0
0
0
0
ENTER EXIT
MENU
INPUT1
SET UP OPTION
:
C O N T R O L S T A ND A RD
:
U N C T I O N OF F
:
U T F I X D E
CHANGE EXIT
MENU
INPUT1
SET UP OPTION
:
C O N T R O L S T A ND A RD
:
U N C T I O N OF F
:
U T F I X D E
CHANGE EXIT
MENU
4
Press SET to select INPUT1 or INPUT4.
The factory default setting is OFF .
Each time SET is pressed the selector function
switches alternately as shown:
3 OFF
INPUT4 2
÷ When OFF is selected, AUTO FUNCTION is
disabled.
÷ After INPUT 1 or INPUT 4 is selected, if a signal is
detected to the selected input jack, the input
function will automatically switch to the selected
input. Thereafter, the input will not change even if
the INPUT button is pressed on the remote control
unit or display.
Once the function has switched to the selected
input by operation of the AUTO FUNCTION facility,
if the input signal is no longer detected at the
selected input jack, the function will automatically
switch back to the original input source used before
the AUTO FUNCTION facility was enabled.
5
Following completion of settings, press MENU
again to return the display to its normal screen.
Note
AUTO FUNCTION for INPUT 1 is supported only when a separate
SYNC or Composite SYNC analog RGB signal is input. (AUTO
FUNCTION is disabled when a G on SYNC or component video
signal is input.)
Other Operations
INPUT1 2
29
En