Installation And Connections; Installing The Video Card - Pioneer PDA-5002 Bedienungsanleitung

Installation and Connections

Installing the Video Card

TO USERS:
This component is sold with the understanding that it will
be installed by a specialist possessing appropriate
technical knowledge and ability.
TO SALES AGENTS:
Installation instructions are noted below. When installing
the unit, if a screw or other object should drop inside the
plasma display, immediately consult your nearest Pioneer
Service Center. Continuing operation may result in
malfunction.
This device has been designed for installation on the
Pioneer Plasma Display PDP-503CMX/PDP-503MXE or
PDP-433CMX/PDP-433MXE.
Installation procedures are as follows:
Confirm the following before installing this video card:
• Disconnect the plasma display from computer or other
components.
• Disconnect the plasma display's power cord from its
outlet.
Installation Notes:
÷ When opening the installation cover, take care not to drop
screws or other objects in the opening. Objects dropped inside
the display may cause damage or malfunction.
÷ When installing the video card, if the plasma display is laid
with its screen side facing down, the work surface should be
flat and level, and either the packing material, a blanket, or
other soft material should be spread on the work surface first
to protect the screen. Take care to prevent scratches or other
damage to the unit from tools or other objects. Never rest the
display on a surface in such a way that weight or pressure is
placed only on the screen surface.
÷ This video card has been designed for exclusive use with the
Pioneer Plasma Display PDP-503CMX/PDP-503MXE or PDP-
433CMX/PDP-433MXE. Do not attempt unauthorized
modifications or alterations since malfunction or damage may
result.
÷ Take care not to modify or damage the card's internal devices
in any way.
÷ Before installation, take precautions to eliminate static
electricity on your body. Do not touch the card's circuitry or
devices.
÷ This device has not been designed to allow reinstallation or
removal; after the card has once been installed on the plasma
display, do not attempt to remove it since damage may result.
Installation
1
Remove the protective cover over the video card
slot on the plasma display's terminal panel.
6
En
2
Insert the video card gently and evenly in
alignment with the two rails visible inside the
installation port.
Note
Be very careful when inserting the card. Insert straight!
The card or display may be damaged if the card is inserted
crooked or with excessive force.
AUDIO INPUT3 S-VIDEO AUDIO
INPUT5
DIGITAL RGB
3
After inserting the video card all the way into the
slot, confirm that it is seated securely, then use
the screws removed in step 1 to secure the card in
place.
INPUT5
DIGITAL RGB
4
Affix the accessory connector indicator label to the
plasma display, and affix the remote control unit
label to the remote control unit furnished with the
plasma display.
DIGITAL RGB
DIGITAL RGB
Note
Use a soft cloth to gently wipe any dust
from the surface before affixing the label.
Video Card Removal (In principle, removal of
the video card should not be attempted).
1
Remove the two screws holding the video card.
INPUT5
DIGITAL RGB
2
Holding the inside tabs, pull the video card out
straight.
AUDIO INPUT3 S-VIDEO AUDIO
INPUT5
DIGITAL RGB
VIDEO OUTPUT
INPUT4
AUDIO S-VIDEO AUDIO VIDEO OUTPUT
INPUT3 INPUT4
AUDIO INPUT3 S-VIDEO AUDIO VIDEO OUTPUT
INPUT5 INPUT4
INPUT5 INPUT3 INPUT4
AUDIO S-VIDEO AUDIO VIDEO OUTPUT
R L R L
AUDIO S-VIDEO AUDIO VIDEO OUTPUT
INPUT3 INPUT4
INPUT4 VIDEO OUTPUT