Part Names And Functions; Connection Panel - Pioneer PDA-5002 Bedienungsanleitung

Part Names and Functions

Connection Panel

R 8Ω ~16Ω
SPEAKER
+ —
1
Plasma Display Section
The plasma display is provided with 2 video input
connectors, 1 video output connector, audio input/output
jacks and speaker terminals.
There are also CONTROL IN/OUT jacks for connection of
PIONEER components with the Î mark.
When this video card is installed on a plasma display, an
additional three sets of video input connectors are
provided (total five), together with one additional video
output connector (total two). See the pages noted in
parentheses ( ) or the plasma display's Operating
Instructions for details regarding connections to the
various jacks and connectors.
1
SPEAKER (R) terminal
For connection of an external right speaker.
Connect a speaker whose impedance is 8 -16 Ω.
2
CONTROL IN/OUT (monaural mini jacks)
For connection of PIONEER components that bear the
Î mark. Making CONTROL connection enables
control of the plasma display as a component in a
system.
3
COMBINATION IN/OUT
DO NOT MAKE ANY CONNECTIONS TO THESE
TERMINALS.
These terminals are used in the factory setup.
4
En
OFF
INPUT5 AUDIO INPUT3 S-VIDEO
R L
DIGITAL RGB
! @ # $
CONTROL COMBINATION RS-232C
IN OUT
IN OUT
2 3 4
AC INLET
ON
- =
AUDIO INPUT4 VIDEO OUTPUT
R L
% ^
INPUT1 (ON SYNC)
OUTPUT
G B
ANALOG RGB (ANALOG RGB)
5 6
4
RS-232C
DO NOT MAKE ANY CONNECTIONS TO THIS
TERMINAL.
This terminal is used in the factory setup.
5
INPUT1 (mini D-sub 15 pin)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or external
RGB decoder; or components equipped with
component output jacks, such as a DVD player. Make
sure that the connection made corresponds to the
format of the signal output from the connected
component (pages 7 to 10).
6
OUTPUT (INPUT1) (mini D-sub 15 pin)
Use the OUTPUT (INPUT1) connector to output the
video signal to an external monitor or other
component.
Note: The video signal will not be output from the
OUTPUT (INPUT1) connector when the main power of
this display is off or in standby mode.
(page 10)
7
INPUT2 (BNC jacks)
For connecting components equipped with RGB
outputs jacks, such as a personal computer or external
RGB decoder; or components equipped with
component output jacks, such as a DVD player. Make
sure that the connection made corresponds to the
format of the signal output from the connected
component (pages 7 to 9).
8Ω ~16Ω
L
SPEAKER
+ —
~
INPUT2 (H/V SYNC) AUDIO
R HD VD
INPUT OUTPUT
(INPUT1/2)
75 Ô 2.2
Ω
kΩ
7 89 0