Panasonic TY-ST20-K Installationsanleitung Seite 12

Assembly Procedure
4. Plasma Display Overturn-Prevention
Anchor the plasma display to both the base and the wall surface.
Anchoring to the base
Attach the overturn-prevention belts
screw holes at both sides of the rear of the pedestal, and use the wood screws
base.
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw
Screw
Front face
Anchoring to the wall
Pass sturdy string, wire, or other such
commercially available item through the
holes at both sides of the rear of the
pedestal, and anchor the string etc. to a
secure wall or pillar.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall
prevention accessories.
※ The details in this section indicate how to reduce any damage or injury caused by this equipment
overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall
prevention accessories will be effective in all earthquake situations.
12
tightening torque: 1.2 to 1.5 N•m)
Overturn-prevention belt
Wood screw
(Cont'd)
(2 belts) to the pedestal using screws
Screw
Locate the wood screw at
the center of the material
width.
(2 screws) through the
(2 screws) to anchor to the
Overturn-prevention
belt
Wood
screw