CAME BPT TA/350 Montageanleitung Seite 46

Enabling and configuring the remote control function
By connecting a special interface to terminals 1-2 (see "Wiring"), it is possible to remotely
change the operating mode of the device. To select the desired mode (cooling or heating),
proceed as follows.
D
E
Enabling and configuring the magnetic contact function
By connecting a magnetic contact to terminals 1-2 (usually a window contact), you can
make sure that the opening of the contact causes the power-off of the thermal zone. The
thermal zone remains off until the contact closes again.
F
TA350
TA350
Press the
button
Use the button to choose one of three
possible configurations E.
Remote contact activation leads to the
activation of one of the following modes:
= Heating
= Cooling
= The remote contact is disabled
After a few seconds of inactivity, the choice
made is recorded.
With the remote contact disabled E
( ) pressing the
gives access to the configuration options
for the magnetic contact.
D.
F button