Silvercrest KH 205 Bedienungsanleitung Seite 53

Installing the appliance
Select a suitable positioning for the sender, close to your
outer door.
Using the assembly plate j of the sender, mark the posi-
tions required for the two boreholes (spacing approx.
68 mm) and then bore the holes for the enclosed wall-
plugs (S6).
Screw the assembly plate j onto the wall.
Carefully slide the plastic covering over the nameplate d
to the side and then remove it.
Write the name(s) of the residents on the plate d and
then replace the plastic covering.
Place the sender on the assembly plate j and secure it,
with the enclosed small screws, to the assembly plate j.
You can install the receiver at a suitable location either
suspended by its loop o or make use of the stand t.
Bear in mind that the given range refers to the free-space
range. If being utilised in a building, this range is re-
duced quite distinctly.
To suspend the receiver, fix the enclosed screw, with the
wallplug, at a suitable location on the wall and hang the
appliance from it.
- 51 -