Turning The Chamber Light On/Off; Installing The Screw Top Adaptor; Serial Connection - Maitre de Vin P140037 Bedienungsanleitung

TURNINg ThE ChAmBER lIghT ON/OFF

Each wine chamber is equipped with two LED
lights to help you identify the bottle inside the
chamber.
• On the control panel (7), press the 'Light'
button (7-f) to switch the light on and off.

INSTAllINg ThE SCREw TOP ADAPTOR

If your wine bottle has a screw top and not a
cork, you need to install the adapter before you
can connect the locking piston.
• Remove the lid of a screw top wine bottle.
• Screw the screw top adapter (18), with the
sealing ring in place, clockwise onto the
screw top wine bottle.
Insert the locking piston into the wine bottle,
using the same method as for a normal wine
bottle (see: 'Installing/Replacing Wine Bottles').

SERIAl CONNECTION

For commercial use, several wine dispensers can
be connetcted with each other.
In this case, only one unit, the master unit, is
connetced to a plug with the detachable power
cord (16), while the first additional dispenser
(slave unit) is connetced to the master unit with
the power cable (19). Further slave units are
connected with each other with additional power
cables (19).
1. Plug the detachable power cord (16) and the
connection power cable (19) into the master
unit. (A1)
2. Plug the other end of the connection power
cable (19) into a second wine dispenser,
which will be used as a slave unit. (B2)
3. Plug the detachable power cord (16) from the
master unit into a 230V power outlet.
4. Switch the main power button (15) of each
connected unit to "ON".
wARNINg: For safety reasons, always finish
steps 1 to 3 BEFORE switching the main
power button on.
5. After the unit is switched on, you will hear the
chambers beginning their cooling cycle and
go to the wine preservation mode. If there are
no bottles in place, the preservation cycle will
stop automatically after several seconds.
wARNINg: For safety reasons, do not connect
more than five wine dispensers (including the
master unit). Always keep a distance of min.
10 cm (4") between the units. Always keep a
distance of min. 10 cm (4") to walls.
P140037-WineDispenser-2014_10_24_English.indd 15
15
24/10/2014 2:38 PM