Herunterladen Diese Seite drucken

Chicco Pocket Relax Bedienungsanleitung Seite 11

Vorschau ausblenden Andere Handbücher für Pocket Relax:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
walls, where strings, curtains or
m
other objects could be used by the
d
child to climb or causing chocking
he
or strangling hazards.
• Do not place the chair near windows
le
or walls to prevent the risk for the
b.
child of overreaching and falling over.
it
• Keep the product out of children's
reach when it is not being used.
e-
• Do not place the reclined cradle
ts
with the child near windows or
walls, where strings, curtains or
or
other objects could be used by the
se
child to climb or causing chocking
or strangling hazards.
o-
• Do not place the chair near windows
by
or walls to prevent the risk for the
child of overreaching and falling over.
h
• Keep the product out of children' s
reach when it is not being used.
es
CARE AND MAINTENANCE
g
FABRIC COMPOSITION
COVER
Outer cover: 100% polyester. Padding: 100% polyester.
ve
• This product requires periodical maintenance.
of
• The cleaning and maintenance operations must only be carried
out by an adult.
c.
• Periodically inspect the reclined cradle to check for broken, torn or
missing parts: If this is the case, do not use it.
ly
• Please refer to the care label for instructions on cleaning the prod-
uct.
ir.
n
Wash by hand in cold water
Do not bleach
m
Do not tumble dry
s-
Do not iron
Do not dry clean
t-
• Check that the fabric and stitching are in good condition each time
you wash it.
• Prolonged exposure to direct sunlight can cause the fabric to fade.
n
To prevent friction from compromising the correct functioning of
the product, make sure that dust and dirt is removed from all mov-
n-
ing parts.
ny
CARRY BAG: 100% polypropylene
Components
le
Structure:
A1 – Base
or
A2 – Feet
A3 – Tubular seat elements
A4 – Backrest
A5 – Open/close buttons
A6 – Open/close junctions
A7 – Recline levers
A8 – Fitting for fabric
Padding:
B1 – Seat
B2 – Safety harness
B3 – Click buttons
B4 – Rigid trim for insertion of fabric
B5 - Seat buttonhole
C – Carry bag
OPENING THE RECLINED CRADLE
The reclined cradle comes already assembled. To use it, the follow-
ing operations must be performed:
- Remove the reclined cradle from carry bag C (Fig.1); during the
opening phase pay attention to the moving parts.
- Take the tubular elements of the seat (A3) and pull outwards (Fig. 2).
- Open fully by pulling the junctions (A6) until they click, checking
that they are firmly in place (Fig. 3).
At this point you can choose the setting you prefer.
- To adjust the angle of the backrest take the two recline levers (A7)
at the same time and pull them upwards (Fig. 4); you can choose
from one of the three possible positions (Fig. 5-6-7). To complete
the operation, release the two levers (A7). This operation may also
be carried out with the child sitting in the reclined cradle.
In this case it can be more difficult.
WARNING: Always guide the backrest (A4) with your fingers when
adjusting the recline angle.
WARNING: Always check that the backrest is properly locked be-
fore use.
FIXED OR ROCKING MODE
The reclined cradle can be used in fixed or rocking mode:
- Fixed mode: turn the two feet (A2) towards the back of the reclined
cradle until the bottom of each foot touches the ground (Fig. 8).
- Rocking mode: turn the feet (A2) in opposite directions, so that the
feet are not touching the ground.
USING THE SAFETY HARNESS
- The safety harness is pre-fitted and ready for use the first time you
use the reclined cradle (Fig. 9).
- To release it, press the toothed ends of the clasp and remove the
two clasps (Fig. 10). The reclined cradle is ready for the child.
WARNING: When using, always fasten the belt by passing it
through the crotch strap and check it is tight enough and in the
right position.
It is possible to alter the tightness of the belt by adjusting it and pass-
ing the strap around the back of the backrest.
- Hold one end of the clasp in place and simultaneously pull the
belt and slide it through the relative ring to adjust the tension of
the safety harness.
CLOSING THE RECLINED CRADLE
- The reclined cradle can be closed for transportation.
- During the closing phase pay attention to the moving parts.
WARNING: The reclined cradle must never be closed with the child
sitting in it. Remove the child from the reclined cradle before closing
the frame!
To close the reclined cradle:
- Completely recline the backrest (A4) according to the indications
in the paragraph "ADJUSTING THE BACKREST" (Fig. 4).
- Press the 2 closing buttons (A5) and push the junctions (A6) to-
wards the centre of the structure (Fig. 11).
- To further compact the structure, push the tubular elements of the
seat (A3) towards each other until the reclined cradle is completely
closed (Fig. 12).
To reopen the reclined cradle follow the operations indicated in the
11

Werbung

loading