Rear View - Pioneer DVD-R100 Bedienungsanleitung

A HARDWARE TOUR

REAR VIEW

1
1 SCSI ID switch
Used to specify the SCSI ID to be assigned to the DVD-R100 drive. When the drive
is to be used on the same SCSI bus as other devices (i.e., when the drive is to be
daisy-chained to other devices), different IDs must be assigned to all devices on the
same SCSI bus.
2 SCSI ports
3 SCSI termination switch
When components are connected through the SCSI connection, the terminator should
be attached to the last component in the connection. In case this drive is the last
component, set this switch to the on position.
4 Reserved
5 Function switch label
Affix the label to the drive bay in which the DVD-R drive has been inserted. (See
No.7 of INSTALLING THE DVD-R DRIVE on p. 11)
6 Ventilation holes
2
6
(when attached to changer)
3 4 5
7
<DRC1146>
En