Pioneer DVD-R100 Bedienungsanleitung Seite 11

6. Attach the rear panel of the Changer.
7. Affix DVD-R drive function switch
label
As the printed instruction on the rear
panel is for a ROM drive, affix the label
to indicate the correct DVD-R drive
functions. (Affix the label so that it covers
the original lettering.)
8. Set the SCSI ID.
For futher details, see A Hardware Tour
(p. 7) and the changer operating manual.
Note:
When setting the SCSI IDs, be careful not
to leave the pointer arrow of the SCSI ID
switch between two figures; be sure to set
the switch so that the arrow points a single
figure.
9. Set the function switches
(SCSI terminator)
Set the terminator switch of the last drive
in the daisy-chain connection to ON.
For futher details, see A Hardware Tour
(p. 7) and the changer operating manual.
INSTALLING THE DVD-R DRIVE
O
N
1
OFF
ON
SCSI Terminator
Function switch
label
2
Reserved
11
<DRC1146>
En