Step 2: Mounting Vtrak In A Rack; E610F/S - Promise VTRAK E610f Kurzanleitung

Step 2: Mounting VTrak in a Rack

E610f/s

The E610f/s subsystem installs to the rack using the supplied mounting rails. You
can also use your existing rails.
Figure 1. VTrak E610f/s mounted in a rack with the supplied rails
Vertical Rack Post
Handles mount
outside the rack post
To install the E610f/s subsystem into a rack with the supplied mounting rails:
1. Check the fit of the mounting rails in your rack system. See Figure 2.
2. Adjust the length of the mounting rails as needed.
• At least two persons are required to safely lift, place, and
attach the VTrak subsystem into a rack system.
• Do not lift or move the VTrak subsystem by the handles,
power supplies or the controller units. Hold the subsystem
itself.
• Do not install the VTrak subsystem into a rack without rails to
support the subsystem.
• Only a qualified electrician who is familiar with the installation
procedure should mount and install the VTrak subsystem.
• Be sure all switches are OFF before installing the VTrak
subsystem or exchanging components.
Step 2: Mounting VTrak in a Rack
VTrak E610f/s
Mounting rails (included)
mount outside the rack post
Cautions
7