Step 6: Connecting The Power - Promise VTRAK E610f Kurzanleitung

VTrak E-Class Quick Start Guide

Step 6: Connecting the Power

Plug the power cords and switch on both power supplies on. When the power is
switched on, the LEDs on the front of the VTrak will light up.
Figure 23.VTrak front panel LED display. The E310f/s is shown. The E610f/s
is similar
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
ten seconds, then blinks green once per second for five seconds again.
• Power, FRU and Logical Drive LEDs display green continuously.
• Controller LEDs flash green if there is activity on that controller.
There are two LEDs on each Drive Carrier. They report the presence of power
and a disk drive, and the current condition of the drive.
Figure 24.VTrak disk drive carrier LEDs
After a few moments the Power/Activity should display Green. If there is no disk
drive in the carrier, the Power/Activity LED will remain dark.
The Power/Activity LED flashes during drive activity.
The Disk Status LED displays Green when a drive is present and configured.
Power
FRU Status
Logical Drive Status
Controller-1 Activity
Controller-2 Activity
Controller Heartbeat
28
Disk Status
Power/Activity