Promise VTRAK E610f Kurzanleitung Seite 30

VTrak E-Class Quick Start Guide
To access the MAC address for VTrak's virtual management port:
• In the CLI, type net -v and press Enter.
In the CLU Main Menu, highlight Network Management and press Enter.
•
Then highlight Virtual and press Enter.
VTrak Default IP Addresses
VTrak uses virtual and physical IP addresses. This arrangement enables you to
access a VTrak with two RAID controllers over your network using a single IP
address.
Virtual Management Port
The default virtual management port IP address is set to 10.0.0.1.
The virtual management port IP address belongs to the VTrak subsystem, not to
the RAID controller. Use the virtual management port IP address to log into the
VTrak over your network.
See "Logging into WebPAM PROe" on page 35.
Physical Management Ports
The default physical management port IP addresses are set to:
• Controller 1 – 10.0.0.2
• Controller 2 – 10.0.0.3
The physical management port IP address belongs to the RAID controller, not to
the VTrak subsystem. Use the physical management port IP address only when a
controller is in maintenance mode .
See Chapter 8 of the VTrak E-Class Product Manual on the CD for more
information.
Setting up with the CLI
1. Type the following string to set the system date and time, then press Enter.
administrator@cli> date -a mod -d 2006/08/25 -t 14:50:05
In the above example, the date and time are included as examples only.
Your values will be different. Use yyyyy/mm/dd for the date and a 24-hour
clock for the time.
2. Type the following string to set the Management Port IP address and other
settings, then press Enter.
administrator@cli> net -a mod -t mgmt -s "primaryip=192.168.10.85,
primaryipmask=255.255.255.0, gateway=192.168.10.1"
30