asalvo WONDER-FIX Gebrauchshinweise Seite 21

2
cHild seat installation
step 1: adjust the child seat
to 2nd position (refer to label
near the guiding hole for lab
belt), push buttons on height-
increasing(4.2a) board and open
the height-increasing board of
the base (4.2B), put the child seat
rearward facing the car seat, and
contact closely with car seat
(4.2c).
step 2: Pull out the vehicle belt,
pass the lap belt through the
guiding hook which is under the
child seat (4.2d), then threading-
out from the other guiding hook
of other side, fasten the buckle
(4.2f) . open 2 shoulder tape
clips on the child seat, put the
diagonal belt into the diagonal
belt guiding hole, and lock the
tap clips, the headrest should be
surrounded by diagonal safety
belt (4.2e) .
step 3: tighten and straighten
the vehicle belt. ensure the seat
is securely install (4.2f).
carry out the operations
described above in reverse order
to take out the child seat, and
ensure all parts of vehicle safety
belt installed tightly.
Make sure the belts installed
correctly and is not twisted.
Check the cover if fit with the
child seat or not
(4.2A).
(4.2B).
2
(4.2C).
(4.2d).
(4.2G).
INSTRUCTIONS
(4.2E).
(4.2F).
EN