Valrom Industrie SOFT 10 Montage- Und Bedienungsanleitung Seite 34

If none of the valve keys is pressed then the valve will complete the Refilling step (30 minutes) and return
to the MAIN MENU without going on with the remaining steps.
If during the time the valve achieves the Refilling step you press any valve key, this one will return to the
MAIN MENU.
3.4.6. Manual regen
When accessing this parameter the valve may achieve an entire regeneration cycle, namely:
It will start with the backwash step, then it will automatically pass through each step, Brine draw, Rinse,
Refill automatically returning to the MAIN MENU re-entering in service after the completion of the entire
regeneration process.
While accessing this parameter by means of the key SET „■", the following window will appear:
3.4.7. Advanced settings
While accessing this parameter by means of the key SET „■", the following window will appear:
Use keys UP „▲" and DOWN „▼" to scroll in this window and to access a parameter use the key SET „■".
In order to return to the preceding menu use key MENU „ ".
3.4.7.1. Backwash duration time settings
Use keys UP „▲" and DOWN „▼" to change values and the key SET „■" to save modifications.
The following window will appear after saving modifications:
34
Regenerating...
Any Key to Cancel
Backwashing...
꞊꞊꞊꞊꞊Advanced Setting꞊꞊꞊꞊꞊
Backwash duration
Brine draw duration
Rinse duration
Refill duration
Regen.Mode
Load Default
꞊꞊꞊꞊꞊Backwash Duration꞊꞊꞊꞊꞊
00 minutes
Press to Return
Press ■ to Confirm
Setting Complete!
Press to Return
5%