Valrom Industrie SOFT 10 Montage- Und Bedienungsanleitung Seite 31

3.2 System initializing
After the valve was connected to the power source, it will automatically pass to the working position and
messages will be displayed on the monitor: System initializing, Please wait.
3.3 Stand-by position
If the valve is programmed in Timer Mode, the following message will be displayed on the valve monitor:
If the valve is programmed in the Meter mode, the following message will be displayed on the valve
monitor:
3.4 Parameter setting
In order to set the parameters press key MENU „ ". For safety after 3 minutes of being not used the menu
will return to stand-by and block itself. Under such circumstances in order to access the setting window of
the valve parameters it is necessary to keep the key MENU „ " pressed for 5 seconds.
After going to the MAIN MENU, the valve parameters will be displayed. In order to select a parameter
with key UP „ ▲" scroll through the menu upwards, and with key DOWN „ ▼" scroll through the menu
downwards. After selecting a parameter, in order to access it press the key SET „■".
In the Main Menu the parameters will be displayed as follows:
3.4.1. Current time setting
When accessing this parameter by means of the key SET „■", the following window will appear:
In order to scroll within the window use the key SET „■", and to modify the values use the keys UP „
▲" and DOWN „ ▼". To confirm the performed modifications press key SET „■". After confirming the
performed modifications the following window will appear:
Pressing the key MENU „
System initializing
Please wait
Current day/Time
00-00-0000 00:00:00
Time of Next Regen
00-00-0000 00:00:00
Current day/Time
00-00-0000 00:00:00
Residual/Total Water
00.00m 0000.00m
3
꞊꞊꞊꞊꞊System Time꞊꞊꞊꞊꞊
00-00-0000 00:00
Press to cancel
Press ■ to confirm
" you will return to the MAIN MENIU.
3
31